Step 5: Connect Coax Cables To Booster - Wilson Electronics weBoost Drive Reach Fleet Guide D'installation

______
Step 5: Connect Coax
Cables To Booster
Connect the cable from the NMO Antenna to the port labeled
"Outside Antenna" on the booster.
NOTE: Bracket can be used to fasten booster in a specific location if desired.
Drive Reach
bracket
Connect the cable from the In-Vehicle Antenna to the port
labeled "Inside Antenna" on the booster.
from Inside Antenna
DRIVE REACH FLEET PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT
from Outside Antenna
9