Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Antenna to the surge protector and ground
the surge protector.
Quick Install
NOTE: Create a "soft" install first by testing
components in your proposed locations
before securing them with hardware.
1.
Select a location on the roof of the
building to install the Outside Antenna.
Make sure the antenna is clear of
obstructions that could block the signal
from the nearest cellular tower.
2.
Select a location to install the A1000-
3G/4G Signal Booster that is well
ventilated and away from excessive
heat, moisture, and direct sunlight.
3.
Select a location for the Inside Antenna
that is in the center of the area where
the signal needs to be amplified
and a minimum of 20 vertical feet or
50 horizontal feet from the Outside
Antenna.
Outside Directional
Antenna
Inside Panel
Antenna
4.
Run the coax cable from the Outside
Antenna to the Signal Booster and
attach it to the connector labeled
"Outside Antenna." Connect another
coax cable to the connector labeled
"Inside Antenna" and run it to the Inside
Antenna. NOTE: Be careful not to bend
the center pins on the connectors when
securing connections.
5.
Once you have ensured all
connections are tight, connect the
Signal Booster to a surge protected
power strip with at least a 1000 Joule
rating to protect your equipment from
power surges and lightning strikes.
(See page 11 for information on
lightning protection)
A1000-3G/4G
Need help?
support-gh@techlineglobal.com
6.
If your A1000-3G/4G is working
correctly, the lights will be green.
If the lights are not green, see the
"Troubleshooting" starting on page 7.
Outside Antenna Installation
1.
Select a location on the roof or an
outside wall where the Outside
Antenna can be mounted without
obstruction (at least three feet of
clearance in all directions) and with
at least 6m of vertical or 15m of
horizontal separation from the Internal
Antenna.
2.
After connecting the coax cable to the
antenna, run it underneath the down
side of your roof's flashing if mounted
on the roof. Tip: Often you can follow
the route used by satellite TV cables.
If you attach the Outside Antenna to a
wall, run the cable along the outside
of the wall to the area where you want
the cable to appear on the inside of
the building, then drill a hole through
the wall where the cable will enter
the building. Caution: Before drilling
holes for the cable, be sure there are
no electrical outlets, wiring, or sewer
or water pipes you could puncture or
sever.
3.
Seal any holes with silicone, cable
bushings or other waterproof sealant.
Signal Booster Installation
1.
Select a location for the Signal
Booster that is away from excessive
heat, direct sunlight, moisture and
well ventilated. The enclosure must
NOT be air tight. Also, be sure the
location is near a power source.
2.
Connect the cables to the Signal
Booster from the Outside Antenna
and Inside Antenna at the designated
ports.
3.
Do NOT connect the Signal Booster
to the power source until all cables
are connected.
5
Publicité
Chapitres
Table des Matières
