Lupine PIKO R Manuel D'utilisation page 33

Problem
The light does not come on
and the power LEDs do not
flash when the battery is
plugged into the lamp.
With the battery plugged in,
the power LEDs do not come
on, but the PCS LEDs flash.
The runtime is too short.
Even after charging only
the 20% LED will light up
at the Smartcore battery.
The lamp does not recogni-
ze the transmitter.
The transmitter does not light
up while pressing the button
and the lamp does not react.
Cause
Extremely discharged battery.

Battery not plugged into the

light or not plugged in
properly.
Faulty LED unit.

Discharged battery.

Old battery.

Very low ambient

temperature.
Faulty charger.

Unsuitable battery.

The indicator was reseted

Lamphead and transmitter

are not linked.
Button cell empty or wrong

side up.
Solution
Charge the battery.

Check all plug contacts.

LED unit needs replacement.

Get in touch with Lupine.

Charge battery.

Replace battery.

Keep battery warm.

Replace charger.

Use original Lupine battery.

Discharge the battery with

your light and fully charge it
afterwards.
See chapter operation

remote control.
See chapter operation

remote control.
Piko R 33