Turntable Installation; Installation And Connection - Cata MC 20 D ENC Manuel Utilisateur

Turntable Installation

Hub (underside)
Glass tray
Turntable shaft
Turntable ring assembly

Installation and connection

1. This appliance is only intended for domestic use.
2. This oven is intended for built-in use only.It is not intended for counter-top use or for
use inside a cupboard.
3. Please observe the special installation instructions.
4. The appliance can be installed in a 60cm wide wall-mounted cupboard (See drawings
1 and 2 at the end of the manual)
5. The appliance is fitted with a plug and must only be connected to a properly installed
earthed socket.
6. The mains voltage must correspond to the voltage specified on the rating plate.
7. The socket must be installed and connecting cable must only be replaced by a
qualified electrician.If the plug is no longer to accessible following installations all-pole
disconnecting device must be present on the installation side with a contact gap of at
lease 3mm.
8. Adapters,multi-way strips and extension leads must not be used. Overloading can
result in a risk of fire.
a. Never place the glass tray upside down. The
glass tray should never be restricted.
b. Both glass tray and turntable ring assembly must
always be used during cooking.
c. All food and containers of food are always placed
on the glass tray for cooking.
d. If glass tray or turntable ring assembly cracks or
breaks, contact your nearest authorized service
center.
The accessible
surface may be hot
during operation.