Foppapedretti 3chic Notice D'utilisation page 13

GB
ASSEMBLY
INSTALL THE SEAT (fig.19, fig.20, fig.21, fig.22, fig.23)
Align the seat with the adaptors and press until "click" sound.
Lift up the buttons of the adaptors with one finger at each side and lift up the seat to remove the
seat.
REVERSIBLE SEAT(fig.24, fig.25, fig.26)
Lift buttons "A" on both sides and remove the seat by lifting it.
Position the seat so that it is forward facing or parent-facing.
Replace the seat on the chassis of the pushchair, see the paragraph "INSTALL THE SEAT" for correct
assembly.
TO REGULATE THE BACKREST (fig.27)
Lift the regulating lever located behind the backrest and recline the backrest to the required
position. Release the lever and make sure the backrest is secured in position.
SAFETY HARNESS (fig.28)
Apply the brake before placing your baby in the pushchair.
Release the buckle: press button "A" and remove the components
Fasten the buckle: by inserting part a in part b, a click will indicate that it has been
fastened correctly.
WARNING: The lap belt is provided with 2 side rings to be used for additional belts in compliance with
the standard BS 6684.
ADJUSTING THE CANOPY (fig.29, fig.30)
Extend the hood according to requirements to protect baby from the sun.
Note: babies' skin is very delicate. NEVER leave baby under direct sunlight. Always make sure that
the hood has been adjusted correctly.
Remove the rear part of the hood to use it as a parasol.
FOLDING THE PUSHCHAIR (fig.31, fig.32, fig.33)
Before folding the pushchair, make sure that:
The seat is forward facing
The backrest is adjusted in the upright position
The canopy is folded
Push the button "A", on the lower side of the right lever and keep pressed while sliding the levers,
left and right, downwards. Fold the stroller. Ensure the locking device "B" is correctly engaged.
Note: It is NOT possible to close the pushchair with the travel system accessories, the infant car seat
and carrycot, fitted on the chassis.
FITTING THE FOOTMUFF (fig.35)
Insert the lower part of the footmuff on the seat of the chassis.
Secure the footmuff to the chassis of the pushchair using the press fasteners.
FITTING THE PUSHCHAIR RAINCOVER (fig.35)
Fit the raincover over the hood.
Fasten the front of the raincover to the chassis of the pushchair using the Velcro tabs.
3CHIC 13