Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6
Then release the knob and allow the burner to heat the hot plate to the suitable
temperature.
7
Your appliance is now ready to be used.
Adjustments
In the event of a change of gas, the injectors must be compulsorily changed (as per
the indications given in the table on page 13/14) and the low heat adjusted.
Changing the injectors:
In the case of an appliance already installed, before changing the injectors and
making new adjustments, shut off the tap from the gas pipe or gas cylinder.
Proceed as follows:
1.
Shut off the tap of the gas pipe or the gas cylinder.
2.
Remove the enamelled steel plate, unscrew the screws holding the burner and
turn the appliance over.
3.
Remove the protection by unscrewing the two screws (see figure 3, page 19).
4.
Push on the burner to distance it from the tap.
5.
Unscrew the injector using a spanner of 10 and get the transformation bag (bag
of injectors).
6.
Change the injectors and seals adhering to the indications in the table of
correspondence of the different types of supply (table, page 12/13).
7.
According to the gas used, the value from the base of the injector to the burner
changes (see figure 2, page 19 and table, page 12/13).
8.
Move the burner along according to the arrow for a new adjustment (see figure
3, page 19).
9.
After repositioning the burner to the recommended value, screw back the screws
in order to block the burner. Close and screw back on the protection of the
appliance. You are advised to write the new configuration on the data plate of
the appliance and erase the old one.
10. Place the changed injector in the transformation bag and store it carefully then
proceed to start up.
Low flame (see figure 4 page 19)
When appliances are adjusted to butane/propane gas, the low heat screw is turned
fully to the right.
If you switch from Butane/Propane gas to Natural gas, this screw must be loosened
until the correct adjustment of the low heat is obtained. The low heat is properly
adjusted if the flame does not go out when going quickly from the maximum position
to the minimum position. The flame must be as low as possible, approximately the
equivalent of a needle head on each hole.
- 16 -
Publicité
Table des Matières
