Haier RDE350AW Manuel D'utilisation page 18

1. Turn the gas supply o by moving the shut-o valve to the closed position.
Closed Valve
Open Valve
2. Disconnect and discard old exible gas connector. Replace with a new
CSA(AGA) approved exible gas connector.
3. Remove the shipping cap from the gas inlet pipe at the rear of the dryer.
4. Connect a " NPT elbow to the gas inlet pipe on the dryer. Then connect a are
adapter to the elbow.
IMPORTANT: Use a pipe wrench to keep the dryer gas inlet pipe from twisting.
Gas Inlet Pipe on
the Dryer
³⁄₈" NPT Elbow
³⁄₈" NPT Flare Adapter
5. Connect the dryer to the gas supply line with a exible gas connector.
Flexible Gas Connector
6. Tighten the exible gas connector using two adjustable wrenches.
7. Turn the gas supply on by moving the shut-o valve to the open position. The
valve is open when the handle is parallel to the gas pipe.
A
A
B
B
C
A
17