CONVERTING TO PROPANE (LP)
4
GAS OR CONVERTING BACK
TO NATURAL GAS FROM
PROPANE (LP)
conversion must be performed by a qualified propane
(LP) gas installer.
The conversion orifices
and instructions can
be found on back of
the range.
Keep these instructions
and all orifices in case
back to natural gas.
NOTE: Location varies
by model.
5
GAS SUPPLY
WARNING
check for gas leaks.
WARNING
Overtightening may damage the pressure regulator
Gas Pressure Regulator
You must use the gas pressure regulator supplied
Natural Gas:
Propane (LP) Gas:
If you are not sure about the inlet pressure contact
local gas supplier.
NOTE:
and should be installed at the rear of the range near
off valve is to be used in the
event that service is required.
remove the toe-kick panel
and reach under the range.
provided for connection to
the range gas inlet.
10
Installation
Cooktop Regulator
Oven
Propane
Regulator
Conversion Kit
Gas Inlet
5
GAS SUPPLY (cont.)
Shut off the main gas supply valve before
disconnecting the old range and leave it off until
the new hook-up has been completed. Don't
forget to relight the pilot on other gas appliances
when you turn the gas back on.
appliance connector is recommended unless local
codes require a hard-piped connection.
connection is made.
A. Install a manual shut-off valve in the gas line in an
easily accessed location outside of the range. Make
NPT internal thread at inlet of the shut-off valve on
valve to avoid damage.
taking care to back-up the shut-off valve to keep it
from turning.
adapter on the range. Position range to permit
connection at the house shut-off valve.
all range controls are in the off position and turn
on the main gas supply valve. Use a liquid leak
detector at all gas connections to check for leaks
in the system.
disconnect the range and individual shut-off valve
from the gas supply piping. When using pressures
system by closing the individual shut-off valve.
operating (manifold) pressure as given on rating label
of product.
31-2000814 Rev. 2