Door Removal - Kenmore 253.22052 Série Guide D'utilisation Et D'entretien

First Steps
CAUTION
To allow door to close and seal
properly, DO NOT let food packages
extend past the front of shelves.
Repositioning the Mid-Level Basket
(some models):
1. To remove the support-hanging
basket, press upward on underside
of front of support to release from
shelf rod.
2. Rotate front under the shelf, and then
slide support-hanging basket forward
to remove from back shelf rod.
3. To remove shelf grommet, slide
away from wall, then pull from rod.
4. Repeat steps 1-3 for other side.
5. With the shelf installed, press the 2
shelf grommets
down onto
the rod that is
anchored into
the appliance
wall (located in
the back only).
Be sure to keep
the larger end of the shelf grommets
away from the wall.
6. Push the shelf
grommets onto
the shelf rod until
firmly seated.
7. Slide the shelf
grommets
into the wall
grommets
already in the
unit wall until
they are flush.
8. Guide the
support-hanging basket underneath
the shelf, inserting the slotted end
of the support
onto the rear
shelf rod.
9. Rotate the
support-hanging
basket up
to bring the
front end over
the front shelf rod. Slide forward to
locate front of support-hanging basket
over front of shelf rod. Push down on
support until it snaps into place.
To install the handle clips to the basket:
1. Place the basket on a firm,
flat surface.
2. With the narrow
side of the
handle clip on
the inside of the
basket, snap the
handle clip to
the recessed area in the basket.
3. Once the inside
surface snaps in
place, continue
the process by
rolling the handle
clip slightly
outward and
pressing down
firmly to snap
onto the outside
surface. If installed incorrectly, the
handle clip will not lay flat.

Door Removal

If door must be removed:
1. Gently lay the unit on its back, on
a rug or blanket.
2. Remove 2 base screws and base panel.
3. Remove wire from clips on bottom
of cabinet if required.
4. Unplug connector, if required, by
holding the cabinet connector
in place and pulling the door
connector out.
5. Remove bottom hinge screws.
6. Remove plastic top hinge cover.
7. Remove screws from top hinge.
8. Remove top hinge from cabinet.
7