Makita AN634H Manuel D'instruction page 11

When using linked sheet nails, the linked sheet will be
ejected from the driver guide as you drive the nails.
Tear away the ejected sheet by twisting as shown in the
figure.
1
► 1. Ejected linked sheet
Removing jammed nails
CAUTION:
Always lock the trigger by turning
the trigger lock lever to the lock position
disconnect the hose before removing jammed
nails. Also remove the nails from the magazine
before cleaning a jam.
1.
Depress the latch lever and open the door. Open
the magazine cap and remove the nail coil.
2. Insert a small metal rod into the nail ejection port
and hit it with a hammer lightly.
3
► 1. Metal rod 2. Nail ejection port 3. Hammer
3. Remove the jammed nail with a flat-blade screw-
driver or other similar tool.
4.
and the door.
MAINTENANCE
inspection or maintenance, always lock the trig-
ger by turning the trigger lock lever to the lock
, and
position
tool.
NOTICE:
alcohol or the like. Discoloration, deformation or
cracks may result.
Cleaning of tool
Iron dust that adhere to the magnet can be blown off by
using an air duster.
1
1
2
► 1. Magnet
Storage
When not in use, disconnect the hose. Then cap the air
fitting with the cap. Store the nailer in a warm and dry
place.
11 ENGLISH
Reset the nail coil and close the magazine cap
CAUTION:
Before attempting to perform
, and disconnect the air hose from the
Never use gasoline, benzine, thinner,