Blumfeldt Heat Guru Turbo Mode D'emploi page 18

EN
18
OPERATION
Important notes on operation
Commissioning and operation
Connect the power plug to a power outlet located in a dry area protected from
water. Then press the switch on the top of the heater, which is used for heat
setting.
• Position (I) for 1000 W
• Position (II) for 1000 W
• Position (I & II) for 2000 W
• In position „0" the heater is switched off.
Note: Although the heater is waterproof, do not use it during rain or in wet
environments. Always unplug the heater from the wall outlet when not in
use.
• The device must not be used
without a rod/post.
• Do not disassemble the device
while it is in operation.
• Do not use the locking knobs
and handle while the device is in
operation.