Glossary; Accessories; Assembly; Contents Of Carton - Craftsman 919.727550 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Become familiar with these terms before operating the
unit.
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per minute; a unit of
measure of air delivery.
PSIG: Pounds per square inch gauge; a unit of meas-
ure of pressure.
Code Certification: Products that bear one or more
of the following marks: UL, CUL, ETL, CETL, have
been evaluated by OSHA certified independent safety
laboratories and meet the applicable Underwriters
Laboratories Standards for Safety.
This unit is capable of powering the following Accessories. The accessories are available through the current
Power and Hand Tool Catalog or full-line Sears stores.

Accessories

In Line Filter
Tire Air Chuck
Quick Connector Sets
(various sizes)
Air Pressure Regulators
Oil Fog Lubricators
Air Hose:
1/4", 5/16" OR 3/8" I.D.
in various lengths

Contents of Carton

1 - Air Compressor
4 - Rubber Feet
1 - 3/8" x 25' Hose
1 - Brad Nailer
2 - 1/4" Quick Connect Body
2 - 1/4' Quick Connect Plug
1 - Roll of Teflon Tape

Tools Required for Assembly

1 - 3/8" socket or nut driver

Assemble Rubber Feet

1. Carefully place unit on side opposite of controls.

GLOSSARY

Cut-In Pressure: While the motor is off, air tank
pressure drops as you continue to use your accesso-
ry. When the tank pressure drops to a certain low
level the motor will restart automatically. The low
pressure at which the motor automatically restarts is
called "cut-in" pressure.
Cut-Out Pressure: When an air compressor is
turned on and begins to run, air pressure in the air
tank begins to build. It builds to a certain high pres-
sure before the motor automatically shuts off - pro-
tecting your air tank from pressure higher than its
capacity. The high pressure at which the motor shuts
off is called "cut-out" pressure.
Branch Circuit: Circuit carrying electricity from elec-
trical panel to outlet.
ACCESSORIES
Specialty Tools
Air Brush
Inflating/Blow Gun
Grease Gun
Caulk Gun
Engine Cleaner
Carpentry Tools
Finishing Nailer / Stapler
Construction Nailer / Stapler

ASSEMBLY

2. Using a 3/8 inch socket or nut driver remove the
NOTE: These screws will be used to install the rub-
ber feet.
3. Attach the four rubber feet to the unit's legs using
NOTE: Flat side of rubber feet goes against unit legs.
7 - ENG
Socket Driving
3/8" Impact/Butterfly Wrench
3/8" Ratchet
1/4" Ratchet
Material Shaping
2.625" Hammer
1.625" Hammer
Reciprocating Saw
Nibbler
Spray Painting
Multi-Purpose Spray Gun
Automotive Spray Gun
screws attaching the unit to the shipping pallet.
the four screws removed in step 2.
Leg
Rubber Foot
Screw
D23122

Publicité

Table des Matières
loading

Table des Matières