Overview; Attaching The Additional Handle; Use; Adjusting The Depth Stop (Sbe 561, Sbe 521, Sb 561) - Metabo SBE 521 Mode D'emploi

17026862_1007 NAFTA SBE BE 561 521 ff.book Seite 7 Donnerstag, 25. Oktober 2007 2:11 14
imperial threads into steel)! The screw head may
break or a high reverse torque may build up.
The machine produces powerful forces when
seizing or catching the workpiece. Always hold the
machine firmly, adopt a steady stance and focus
on your work.
Secure small workpieces. For example, clamp in a
vice.
SYMBOLS ON THE TOOL:
.......Class II Construction
V...........volts
A...........amperes
Hz.........hertz
BPM .....beat per minute
~
..........alternating current

4 Overview

See page 3 (please unfold).
1 Chuck key (for geared chuck) *
2 Geared chuck *
3 Futuro Plus keyless chuck *
4 Depth stop *
5 Additional handle *
6 Direction switch *
7 Sliding switch for normal drilling/impact
drilling *
8 Lock button (continuous operation)
9 Trigger
10 Speed preselection wheel *
* depending on the features / model
5 Commissioning
Before plugging in, check to see that the
rated mains voltage and mains frequency,
as stated on the rating label, match with your
power supply.

SBE 561, SBE 521, BE 561:

Make sure the chuck clamps securely:
After drilling for the first time (clockwise), firmly
tighten the safety screw inside the chuck using a
screwdriver. Caution: left-handed thread! (see
Section 6.8)
5.1

Attaching the Additional Handle

(SBE 561, SBE 521, SB 561)

For safety reasons, always use the addi-
tional handle supplied.
Open the clamping ring by turning the additional
handle (5) anticlockwise. Push the additional
handle onto the collar of the machine. Insert the
depth stop (4). Securely tighten the additional
handle at the angle required for the application.

6 Use

6.1 Adjusting the Depth Stop
(SBE 561, SBE 521, SB 561)
Loosen the additional handle (5). Set depth stop (4)
to the desired drilling depth and retighten addi-
tional handle.
6.2

Switching On and Off

To start the machine, press the trigger switch (9).
SBE 561, SBE 521, BE 561: Press in the trigger
switch to change the speed.
For continuous operation the trigger switch can be
locked using the lock button (8). To stop the
machine, press the trigger switch again.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine
with both hands using the handles provided,
stand in a safe position and concentrate.
6.3

Speed Preselection

(SBE 561, SBE 521, BE 561)
Select the (10) maximum speed using the prese-
lection wheel. See page 4 for recommended
drilling speeds.
6.4 Switching Between Normal Drilling/
Impact Drilling
(SBE 561, SBE 521, SB 561)
Select the desired operating mode by pushing the
sliding switch (7).
Drilling
Impact drilling
Work with high speed settings when impact
drilling.
Impact drilling and normal drilling only in a
clockwise direction.
6.5

Selecting the Direction of Rotation

(SBE 561, SBE 521, BE 561)
Do not activate the direction switch (6)
unless the motor has completely stopped.
ENGLISH
ENG
7