Functional Description; Battery Cartridge - Makita HXU01 Manuel D'instruction

FUNCTIONAL DESCRIPTION

WARNING:
Always be sure that the tool is switched off and
•
the battery cartridge is
adjusting or checking functions on the tool.
Failure to switch off and remove the battery
cartridge may result in serious personal injury from
accidental start-up.
Installing or removing battery cartridge
CAUTION:
Hold the tool and the battery cartridge firmly
•
when installing or removing battery cartridge.
Failure to hold the tool and the battery cartridge
firmly may cause them to slip off your hands and
result in damage to the tool and battery cartridge
and a personal injury.
Always switch off the tool before installing or
•
removing of the battery cartridge.
2
1
012942
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Always insert it all the way until it locks in
place with a little click. If you can see the red indicator on
the upper side of the button, it is not locked completely.
Install it fully until the red indicator cannot be seen. If not,
it may accidentally fall out of the tool, causing injury to
you or someone around you.
NOTE:
Do not use force when installing the battery
•
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
Power switch action
WARNING:
Before inserting the battery cartridge in the tool,
•
always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released. Do not pull the switch
trigger hard without pressing in the lock-off
removed before
1. Red indicator
2. Button
3. Battery
cartridge
3
button. This can cause switch breakage. Operating
a tool with a switch that does not actuate properly can
lead to loss of control and serious personal injury.
2
010814
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, press in the lock-off button and pull the
switch trigger. The tool speed is increased by increasing
pressure on the switch trigger. Release the switch trigger
to stop.
Reversing Switch for Debris Removal
1
010825
This tool has a reversing switch. To remove debris
jammed or entangled in the tool, depress the "B" side of
the switch to reverse the rotation. For normal operation,
depress the "A" side of the switch.
NOTICE:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage it.
Speed change
010815
Two speed ranges can be preselected with the speed
change switch.
6
1. Lock-off button
1
2. Switch trigger
1. Reversing switch
2. A position
depressed for
normal
operation
3. B position
depressed for
weed and debris
removal
1. Speed change
switch lever
1