MAINTENANCE
a) Check mounting bolts at frequent intervals for
proper tightness to be sure equipment is in safe
working condition.
b) Apply oil at all pivot points.
DRIVE MECHANISM DISMOUNTING
SEE
ATTACHMENT
(SNOWBLOWER,
BROOM
DISMOUNTING INSTRUCTIONS.
a) Dismount the attachment.
b) Remove the rear counterweight when you remove
the front attachment.
c) Dismount the drive mechanism by disconnecting
the clutch rod and by removing the pins in front.
Carefully lower to the ground. Detach the V-belt
from engine pulley.
d) You may leave the subframe on tractor all year long
or remove it if preferred.
e) Reinstall mower if needed.
MAINTENANCE & DISMOUNTING
OWNER'S
MANUAL
AND
BLADE)
FOR
BELT REPLACEMENT
Drive Mechanism Belt:
Before proceeding with this step, notice carefully how
the belt guide is installed to avoid damage to the belt.
When re-installing, remove the bolt which retains the
tension pulley and the belt guide. Replace the belt
and re-install the tension pulley and belt guide. Before
tightening make sure the belt guide does not touch
the belt at any time. Re-install the drive mechanism.
END OF SEASON STORAGE
a) Clean and paint all parts from which paint has worn.
b) Apply oil at all pivot points.
c) Inspect and replace all defective parts before using
again.
15