Utility Blade Installation - Bercomac 700279-3 Mode D'emploi

UTILITY BLADE INSTALLATION:

Refer to Utility Blade owner's manual, parts
breakdown section for parts identification.
9
WARNING
FOR YOUR SECURITY:
Read the Utility Blade owner's manual for safety
precautions and rules.
Follow the assembly and operation instructions.
Attach the blade to the subframe as shown.
Make sure the blade is pushed in until locked into
place by the springs (item 1).
Insert the handgrip on the handle.
Insert the handle (item 1) through the support (item 2)
as shown.
Install the handle on the control rod (item 3) as shown
and secure with a 2.5 mm hair pin (item 4).
VERIFY TIRE PRESSURE:
Attachments should raise 3" to 4" above the ground
(no more, no less) if not, check and adjust tractor tire
pressure as follows:
Front tires:
Back tires:
Tire pressure must be even on both sides of the
tractor.
ASSEMBLY
14-15 psi
7-8 psi
9
14
Attach Utility Blade to subframe
Install handle