Rotary Broom Installation - Bercomac 700279-3 Mode D'emploi

ROTARY BROOM INSTALLATION:

Refer to Rotary Broom owner's manual, parts
breakdown section for parts identification.
9
WARNING
FOR YOUR SECURITY:
Read the Rotary Broom owner's manual for
safety precautions and rules.
Follow the assembly and operation instructions.
Attach the rotary broom to the subframe as shown.
Make sure the rotary broom is pushed in until locked
into place by the springs (item 1).
Install the belt on the drive mechanism pulley (item 1)
as shown.
NOTE: See belt replacement instructions in the
maintenance section of the rotary broom owner's
manual.
9
CAUTION
Never use the Rotary Broom without the belt
guard.
VERIFY BELT ROUTING:
-Lower the rotary broom to the ground and let it run
for a few seconds under supervision.
-Disengage the rotary broom and stop the engine.
-Check the belts to make sure they are well inserted
on the pulleys and have not flipped on their sides in
the pulleys and that they do not touch the belt
guides.
ASSEMBLY
9
TO PREVENT INJURIES:
9
Stop the motor.
Apply parking brake.
Remove the ignition key.
Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent accidental
starting.
9
Item 1: Drive mechanism pulley
Item 2: Rotary broom pulley
12
WARNING
Attach rotary broom to subframe
9
Install belt