Emerson Appleton Baymaster HL Instructions D'installation page 3

Wiring
WARNING: The luminaire must be grounded as required by the National Electrical Code (Paragraph 410-21 and Article 250) or
Canadian Electrical Code (Rule 30-500 and Section 10). Verify that ground continuity has been established by using an Ohm meter
or other suitable testing equipment before energizing the luminaire. Failure to properly ground the luminaire will create an electric
shock hazard, which can cause serious injury or death.
Wiring the Baymaster High Lumen LED Luminaire
1. Open the luminaire wiring compartment by loosening the four captive screws. Allow the cover to swing open, exposing the
wiring compartment.
2. Insert the cable/conduit through the conduit entry (with appropriate fitting attached) to the luminaire wiring compartment.
3. Strip the individual conductors to bare wire and insert them into the proper terminal block connectors. The connection points
are identified on the terminal block as: "L" = Line, "N" = Neutral and "G" = Ground. Tighten down the terminal block screws
onto the wire.
4. Once the terminal block is wired to incoming power, close the luminaire wiring compartment cover.
5. Tighten the four captive screws by applying a minimum of 14 in.-lb using an (x) pattern.
6. Close all unused conduit entries with close-up plugs (provided). Make sure to tighten unused close-up plugs to 400 in.-lb
after applying TLNC4 grease. TLNC4 grease shall be applied in 3 lines, spaced approximately 120 degrees apart, perpendicular
to the threads.
7. Power can now be applied to the luminaire.
.
Figure 2: (x) Pattern
Appleton • 1.800.621.1506 • www.appletonelec.com 650547-000 Rev. A 06/29/17 • Page 3 of 10