Switching Power Supply Maintenance; Device Control; Description Of The Units Functions; System Modes - Salda SMARTY XV Manuel De Montage Et D'installation

18.7. SWITCHING POWER SUPPLY MAINTENANCE

• Unscrew screw at the front side;
• After loosening power supply, lift it up in order to disconnect connector below. (2-3).
• Power supply is under the protection cover. Please remove the cover in order to change it (4-5). Then release power supply from the base (6-7).
• Perform assembly in the reverse order.
• Connectors are marked according connection place, therefore, please, pay attention to the marking.
1.

19. DEVICE CONTROL

Ventilation unit can be controlled using a remote control, web interface via MB-Gateway and building management system. More information about
the possibilities of controlling is provided in the table below.
MB-Gateway + WIFI + SALDA AIR app
+

19.1. DESCRIPTION OF THE UNITS FUNCTIONS

All functions indicated in this section are installed in the software of the control board. However, operation and control of the device depends on
the following:
Selected control panel. Full functionality and configuration possibility can be assured only by MB-Gateway web interface SA-Control, SALDA AIR
app.
Connected external devices: external heaters, dampers, sensors and etc. (see the description of the acquired air handling system).
Internal components of the device: type of heat exchanger (plate or rotor), integrated dampers, sensors and etc. (see components of the chosen
device).
Control board type.
Air Handling Unit uses MCB board.
The unit can be configured only with SA-Control remote con trol panel, MB-Gateway web application or SALDA AIR app.
The following control board functions can be fully con trolled only with SA-Control remote con trol panel, MB-Gateway web
application or SALDA AIR app. In case of Stouch remote con trol panel use the description of remote control panel functions
for MCB control board.

19.2. SYSTEM MODES

Stand-by;
Building protection;
Economy;
Comfort.
In Stand-by mode the system is shut down for a permissible period (based on the Stand-by mode blocking function settings).
SMARTY XV v2019.06
4. 5.
Stouch FLEX MCB
+ +
2.
6.
SA-Control MB-Gateway
+ +
3.
7.
BMS
Modbus RTU
FR | 17