Cleaning And Maintenance - emerio TFN-214472.1 Mode D'emploi

Replacing the filter alarm clock
The appliance has a memory function. After a total of 720 hours of operation, the digital display (as shown in the
figure) will light up for about 5 seconds with the indicator light cycling when the appliance is turned on.
After replacing the filter, press and hold the on/off button on the remote control for 5 seconds to clear the alarm
and the operating time of the filter reclocks again.
LOCATION
Please place the appliance in a horizontal position. Please do not use the appliance in high temperature and
humidity (bathroom, kitchen).
Do not cover
Do not place anything within 1 meter.
SAFETY SYSTEM
This appliance is equipped with an overheat protection sensor and an automatic fail-safe that cuts power to the
unit if it is accidentally tipped over or overheat. If this sensor is triggered, unplug the machine and allow it to
cool. Check and remove any obstructions before restarting the appliance and be sure to place it on a hard and
level surface.

CLEANING AND MAINTENANCE

Unplug the appliance before cleaning and maintenance.

Please do not put the appliance on the water or splash it, which may cause damage to the machine.

Do not use banana oil, benzine, alcohol, bleach or metal objects to wipe the surface of the appliance, which

may cause discoloration of the surface.
Wipe the surface with a soft, dry cloth. If especially dirty, dilute with a mild detergent and wipe with a soft

cloth. Then wipe with a dry cloth.
Use a soft brush or a vacuum cleaner to clean the dust at the air inlet and outlet. Please clean it when there

is less dust. Too much dust will reduce the efficiency.
Keep a distance
- 9 -