Brewing Temperature - Arzum OKKA OK001 Mode D'emploi

Boiling point
The boiling point of water depends on the
altitude above sea level. The appliance deter-
mines the boiling point automatically.
When the appliance is used for the first time,
the boiling point is set immediately. The wa-
ter chamber should be filled before turning
the appliance on. The boiling point must be
set again if the height above sea level has
changed:
Reset the boiling point
1.Fill the water chamber and make sure the
waste water tray is empty.
2. Remove the brewing head by turning it an-
ticlockwise.
3.Press the and
until the LEDs start to flash.
4.Reattach the brewing head by turning it
clockwise and make sure it is securely locked
into position.
5.After 3 seconds, an acoustic signal is emit-
ted and the boiling point detection process
starts.
22 ARZUM OKKA
buttons at the same time

Brewing temperature

The coffee brewing temperature can be set
individually. To do so, remove the brewing
head by turning it anti-clockwise
Increasing the temperature
Keep the button pressed. Each time the
button is pressed, the temperature increases
by 1 C.
Decreasing the temperature
Keep the button pressed. Each time the
button is pressed, the temperature decreases
by 1 C.
Reset the temperature
Press the and buttons simultaneously for
about 1 second.
Thee acoustic signals indicate min. or max.
temperature is reached. Reattach the brew-
ing head by turning it clockwise.
Warnings
Upper LED :
Water chamber empty or not fitted properly.
Middle LED :
Brewing chamber head bot fitted properly.
Lower LED :
Waste water tray is full or not fitted properly.
An acoustic signal indicates that a process
has been finished, a function has been se-
lected or a component has been removed or
reattached.