Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Washer Symptom
Er, nF on digital display
Er, OF on digital display
Er, PS on digital display
Er, dU on digital display
Er, dl on digital display
Er, ub on digital display
or
Left Decimal Point blinking on display one second on/one
second off
PF on digital display
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
All manuals and user guides at all-guides.com
• The washer has not filled to the proper water level.
• No or very little change in water level has been sensed
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Clean the screens in the water mixing valve and the filter
• Unplug the machine for 15 seconds to clear this code.
• This code indicates the washer has filled to the overflow
• The machine will begin to attempt to pump water out if the
• Foreign object trap in pump may be clogged. Clean the
• If the code does not clear, unplug the machine and call for
• The control has detected trouble sensing the water fill lev-
• Unplug the machine and call for service.
• The control senses that the door will not unlock.
• Unplug the machine for three minutes to unlock the door.
• If the code appears again, call for service.
• This code indicates that the door has not locked.
• Make sure the door is closed all the way and try to start
• Open the door or unplug the machine to clear the code.
• If this code continues, call for service.
• This code indicates that the washer did not reach the maxi-
• This could be due to an unbalanced load, excessive suds
• Be sure to use proper load sizes that are evenly distributed
• Be sure to use high efficiency (HE) detergent.
• Open the door or press the Power/Cancel keypad to clear
• This code will be displayed if the control was in Delay Start
• The delayed start will be canceled.
• Press the Power/Cancel Pad to clear the code.
30
Possible/Cause Solution
within 5 minutes of the current fill.
screens located at the faucet end of the fill hoses.
level.
door is closed and locked.
trap. Refer to Maintenance section.
service.
el.
the cycle.
mum intended speed in the final spin.
in the load, or too much water left in the tub due to slow
draining.
in the wash basket.
this code.
Mode when a power failure occurred.
Table continues...
Part No. 806974EN
Publicité
Table des Matières
Dépannage
