Speed Queen SF7001WE Guide De L'utilisateur page 29

Washer Symptom
Is Noisy
Load is Too Wet
Wrong Water Temperature
Control not responding to keypad selections
Er, do on digital display
Er, dL on digital display
Er, dr on digital display
Er, FL on digital display
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
All manuals and user guides at all-guides.com
• Make sure washer is level. Uneven leveling can cause vi-
• Some sounds may be a part of normal operation for a
• When rotating the tub slowly you will hear the balance balls
• Wash load may be unbalanced. The washer may have limi-
• Load is too small. Add items to make full load.
• Make sure that the controls are properly set.
• Check fill hoses. Make sure hot faucet hose is connected
• Make sure laundry room water heater is adjusted properly.
• The Normal Eco cycle uses a colder water temperature.
• Make sure Control Lock feature is off. If on, Control Lock
• Press and hold Signal Keypad for three seconds to turn off.
• The control senses that the door is open during a running
• Unplug the machine to clear this code.
• The control senses that the door has unlocked during a
• Unplug the machine to clear this code.
• This code indicates that water is still in the washer at the
• Check the drain hose and drain receptacle to make sure
• Foreign object trap in pump may be clogged. Clean the
• Unplug the machine for 15 seconds to clear this code.
• This code will appear if the washer has not reached the fill
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Clean the screens in the water mixing valve and the filter
• Unplug the machine for 15 seconds to clear this code.
29
Possible/Cause Solution
bration.
frontload washer, such as clicking noise when door locks
and unlocks, and clicking noise from balance ring during
agitate part of cycle.
click together. This noise is normal and does not require a
service call.
ted the spin speed to prevent damage to the machine. Re-
distribute the load and run a Spin cycle.
to hot mixing valve (indicated with "H" on the valve brack-
et) and cold faucet is connected to cold mixing valve (indi-
cated with "C" on the valve bracket).
light will be lit.
cycle.
running cycle.
end of the cycle.
they are installed properly and not blocked.
trap. Refer to Maintenance section.
level after 30 minutes during a wash or rinse fill.
screens located at the faucet end of the fill hoses.
Troubleshooting
Table continues...
Part No. 806974EN