Declaration Of Conformity; Auxiliary Handle - Bosch PSB 530 RA Instructions D'emploi

Declaration of Conformity

We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents: EN 60745 according to
the provisions of the
98/37/EC.
Dr. Egbert Schneider
Senior Vice President
Engineering
16.04.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Assembly
Before any work on the machine itself, pull
the mains plug.
Dust/Chip Extraction
(PSB 530 RA/PSB 650 RA)
(see figure A)
Use the dust/chip extraction only when work-
ing concrete, brick and brickwork. Wood or
plastic chips can easily lead to clogging.
WARNING Fire hazard! Do not work metallic
materials with the extraction device mounted.
Hot metal chips can ignite parts of the extraction device.
To achieve optimum extraction results, please observe
the following notes:
• Pay attention that the extraction device faces flush
against the workpiece or the wall. This also makes
drilling at a right angle easier.
• When using the extraction device, always work with
the maximum speed.
• After reaching the desired drilling depth, pull the
drill bit out of the drill hole first and then switch off
the impact drill.
16 | English
All manuals and user guides at all-guides.com
directives 89/336/EEC,
Dr. Eckerhard Strötgen
Head of Product
Certification
• Check the condition of the filter element 19 regu-
larly. Replace a damaged filter element immediately.
• The dust protection ring 16 can wear, especially
when working with large drill-bit diameters. Replace
the dust protection ring when worn/damaged.
Mounting the Extraction Device
Guide the extraction device 9 from the front toward the
bottom side of the impact drill. Pay attention that the
extraction device 9 faces flush against the casing and
that it is locked.
Cleaning the Extraction Device (see figure A)
Attach the locking latch 17 or empty the dust collector
15 before placing down the extraction device.
The dust collector 15 is sufficient for approx. 20 drill-
ings with a drilling diameter of 6 mm.
When the extraction force diminishes or when the level
indicator 20 is full, the dust collector 15 must be emp-
tied. For this, press on the riffled surface of the release
button 14 and take off the dust collector 15.
Empty and clean the dust collector 15. Clean the filter
element 19 by gently striking or tapping against it.
Check the filter element 19 for damage and replace it
as required.
For this, as an example, pry off the holder of the filter
element 19 ( ) and change the filter element 19 includ-
ing the holder ( ). When placing on the holder again,
make sure that the rubber gasket is inserted.
Reattach the dust collector 15 again and lock it by
pressing against the smooth surface of the release but-
ton 14.
Removing the Extraction Device
For removal of the extraction device 9, push the release
button 18 to the right or left and pull off the extraction
device 9 toward the front.

Auxiliary Handle

Operate your machine only with the auxiliary
handle 11.
The auxiliary handle 11 can be set to any position for a
secure and low-fatigue working posture.
Turn the wing bolt for adjustment of the auxiliary
handle 10 in anticlockwise direction and set the auxil-
iary handle 11 to the required position. Then tighten the
wing bolt 10 again in clockwise direction.
Adjusting the Drilling Depth
(PSB 530 RA/PSB 650 RA) (see figure B–C)
With the extraction device mounted, the drilling depth
"X" can be adjusted.
2 609 002 371 • 11.5.07