Safety Of Others; Vibration - Batavia BT-JCS001 Mode D'emploi

Electric chainsaw
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

contacting anything.
• Pre-plan a safe exit from falling branches
and debris. Ensure the exit route is clear of
obstacles that would prevent or hinder
movement. Remember wet grass and
freshly cut bark is slippery.
• Be aware of the direction that a branch may
fall. Consider all conditions that may affect
the direction of fall, including:
- The intended direction of fall.
- The natural lean of the branch.
- Any unusual heavy limb structure or decay.
- Surrounding trees and obstacles including
overhead lines.
- The wind speed and direction.
• The safe distance between a branch and
debris to be felled and bystanders,
buildings and other objects is at least 2 1/2
times the length of the branch. Any
bystander, building or object within this
distance is at risk from being struck by the
falling branch.
• When cutting a limb that is under tension,
be aware of spring-back. When the tension
in the wood fibres are released the spring
loaded limb may strike the operator and/or
throw the tool out of control.
• Always wear suitable safety equipment
such as nonskid safety shoes, hard hat,
goggles, ear protection and gloves when
operating the tool.
• Ensure someone is nearby (at a safe
distance) in case of an accident.
• Do not attempt to operate the tool when in
a tree, on a ladder or standing on any other
unstable support.
• Keep proper footing and balance at all
times.
• Hold the tool firmly with both hands when
the motor is running.
• Keep handles dry, clean and free from oil
and grease. Greasy oily handles are
slippery causing loss of control.
• Do not let the moving chain contact any
object at the tip of the chain guide bar.
22
Croc Saw Manual.indb 22
All manuals and user guides at all-guides.com
• Keep your saw chain properly tensioned.
• Begin and continue cutting only with the
• Watch for shifting branches or other forces
• Use extreme caution when re-entering a
• Use of this tool for operation different to
• If any debris gets caught with the guard or
• Worn chains and chain guide bars should
• Only use replacement bars and chains

SAFETY OF OTHERS

• This tool is not intended for use by persons
• Children should be supervised to ensure

VIBRATION

The declared vibration emission values stated
in the technical data and the declaration of
conformity have been measured in
accordance with a standard test method
provided by EN 60745 and may be used for
comparing one tool with another. The declared
vibration emission value may also be used in a
TM
Check tension at regular intervals with the
motor stopped and cord disconnected.
chain moving at full speed.
that could close a cut and pinch or fall into
the chain.
previous cut. Engage spikes on lower jaw
into wood and allow the chain to reach full
speed before proceeding with cut.
those intended could result in hazardous
situations. Cut wood only. Don't use this
tool for purposes not intended – for
example - Don't use tool for cutting plastic,
masonry or non-wood building materials.
tool discontinue use, disconnect the power
cord and clear debris.
be replaced.
specified by the manufacturer.
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they
have been given supervision or instruction
concerning the use of the appliance by a
person responsible for their safety.
that they do not play with the appliance.
24-04-14 11:18

Publicité

Table des Matières

Dépannage

loading

Ce manuel est également adapté pour:

7062040

Table des Matières