Applications; Adding Bar And Chain Lubricant - Batavia BT-JCS001 Mode D'emploi

Warning: Never position the front
handle so that it is forward of the vertical
upright position. Positioning the handle in this
forward area could cause the operator to lose
control of the electric chainsaw and result in
serious personal injury.
See Figure 4.
Danger: Never cut near power lines,
electric cords, or other electric sources. If
bar and chain jams on any electrical cord
or line, DO NOT TOUCH THE BAR OF
CHAIN! THEY CAN BECOME
ELECTRICALLY LIVE AND VERY
DANGEROUS.
Continue to hold the lopper by the
insulated rear handle or lay it down and
away from you in a safe manner.
Disconnect the electrical service to the
damaged line or cord before attempting to
free the bar and chain from the line or cord.
Contact with bar, chain, other conductive
parts of the electric chainsaw, or live
electric cord or lines will result in death by
electrocution, electric shock, or serious
personal injury.
Warning: Do not operate the electric
chainsaw if the upper or lower guard is broken,
cracked, missing, or damaged in any way.
Operating the lopper with missing or damaged
guards could result in accidental contact with
the moving chain and cause serious personal
injury.
Warning: Do not allow familiarity with
this product to make you careless. Remember
that a careless fraction of a second is sufficient
to inflict serious injury.
Warning: Always wear eye protection
with side shields along with head protection.
26
Croc Saw Manual.indb 26
All manuals and user guides at all-guides.com
Failure to do so could result in objects being
thrown into your eyes and other possible
serious injuries.
accessories not recommended by the
manufacturer of this product. The use of
attachments or accessories not recommended
can result in serious personal injury.
handle so that it is forward to the vertical
upright position. Positioning the handle in this
forward area could cause the operator to lose
control of the electric chainsaw and result in
serious personal injury.

APPLICATIONS:

You may use this product for the purposed
listed below:
• Limbing
• Pruning

ADDING BAR AND CHAIN LUBRICANT

See Figure 5.
Use Premium Bar and Chain Lubricant. It is
designed for chains and chain oilers, and is
formulated to perform over a wide temperature
range with no dilution required.
NOTE: Lopper comes from the factory with no
bar and chain oil added. Level should also be
checked after every 20 minutes of use and
refilled as needed.
• Disconnect the lopper from the power
• Remove oil reservoir cap
• Carefully pour the bar and chain lubricant
TM
Warning: Do no use any attachments or
Warning: Never position the front
supply
into the tank
24-04-14 11:18