Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
preliminary assessment of exposure.
Warning! The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in
which the tool is used. The vibration level may
increase above the level stated. When
assessing vibration exposure to determine
safety measures required by 2002/44/EC to
protect persons regularly using power tools in
employment, an estimation of vibration
exposure should consider, the actual
conditions of use and the way the tool is used,
including taking account of all parts of the
operating cycle such as the times when the
tool is switched off and when it is running idle
in addition to the trigger time.
LABELS ON TOOLS
The following symbols are found on your tool:
Warning! To reduce the risk of injury,
the user must read the instruction
manual.
Do not use your saw in wet conditions
or expose it to rain.
Always wear head, hearing and eye
protection.
Beware of falling objects.
Keep bystanders away.
Do not use on ladders.
Check the chain tension after every
10 minutes of use. Adjust back to a
clearance of 3 mm.
Warning! Do not touch chain at the
chipping ejection point.
Direction of travel of the chain.
Croc Saw Manual.indb 23
All manuals and user guides at all-guides.com
ELECTRICAL SAFETY
• If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorized Service Centre in order to avoid
a hazard
USING AN EXTENSION CABLE
• Always use an approved extension cable
suitable for the power input of this tool (see
technical data). The extension cable must
be suitable for outdoor use and marked
accordingly. Up to 30 m of 1.5 mm²
HO5VV-F extension cable can be used
without loss of product performance. Before
use, inspect the extension cable for signs of
damage, wear and ageing. Replace the
extension cable if damaged or defective.
When using a cable reel, always unwind
the cable completely.
RESIDUAL RISK
Despite the application of the relevant safety
regulations and the implementation of safety
measures, certain residual risks are inherent
to the use of wood cutting saws and cannot be
avoided. These are:
• Risk of injury arising from contact with
moving parts, sharp parts, hot parts,
branches or debris falling on the operator,
bystanders or property, debris ejected by
the tool.
• Risk of injury arising from un-intended use,
falling from a ladder or working position in a
tree, damage to the supply cable, use of
Immediately disconnect the cable
from the mains if it is damaged or
cut.
This tool is double insulated;
therefore no earth wire is required.
Always check that the power supply
corresponds to the voltage on the
rating plate.
EN
23
24-04-14 11:18
Publicité
Table des Matières
Dépannage
