Subaru E721SAN031XX Mode D'emploi page 15

Les langues disponibles

STEP 30: While tensioning the LH torsion bar, move the RH hinge link off the LH torsion bar (1). Then carefully unhook the torsion bar off

the RH hinge bracket (2) - see diagram (photo taken from rear seat) to lift up and then carefully pull towards the rear. Dislodge torsion bar

from the bottom position of the center bracket clip (3).

(3) Center Bracket Clip

(not shown)

STEP 31: While still holding the torsion bar tool, support the center of torsion bar with other hand and angle it downward (1). Remove

torsion bar from the anchor bracket by pulling to the right (2). Remove safety pin and remove the tool from the torsion bar. Dispose of the

original torsion bar.

PART NUMBER:

E721SAN031XX

PART NUMBER: E721SAN031XX

LH Torsion Bar

ISSUE

10/27/2021

(2) RH Hinge Bracket

(1) RH Hinge Link

SUBARU OF AMERICA

PAGE 15 / 17