FAAC SAFEzone RETROFIT KIT Guide Rapide page 20

Display Basic Function
Pb PAUSE TIME B
Is the pause time in a PARTIAL opening (it is effective only if a logic with pause
time has been selected).
Adjustable from
Next the value 59, the viewing changes to minutes and tenths of a second
(separated by a decimal point) and time is adjusted in 10-second steps up to
the maximum value of
Es: if the display shows
Mn NR. OF MOTORS:
You can select the number of motors present in the system:
1
= 1 motor
2
= 2 motors
If the SETUP is performed with only one motor, and later two mo-
tors are used, the board will signal error
which can be deleted by repeating the SETUP with two motors or
by returning to one motor.
If a SETUP is performed with two motors and later only one is used,
the board will not signal an error. Only the motor connected to input
M1 will move.
When programming from a PC/MAC, you can select different partial
openings.
F1 MOTOR 1 POWER:
You can adjust the maximum power of motor 1, which is the same during
both opening and closing.
01
= minimum power
50
= maximum power
If the power is modified, we recommend performing a new SETUP
- see the related paragraph.
If hydraulic motors are used, power must be programmed to maximum
level (
F2
MOTOR 2 POWER (visualised only with the function
You can adjust the maximum power of motor 2, which is the same during
both opening and closing.
01
= minimum power
50
= maximum power
If the power is modified, we recommend performing a new SETUP
- see the related paragraph.
If hydraulic motors are used, power must be programmed to maximum
level (
SAFEzone RETROFIT KIT
(visualised only with Automatic logics):
00 59
to sec, in 1-second steps.
9.5
minutes.
2.5
, the time is 2 min and 50 sec.
50
).
50
).
14
- configuration error,
Mn
4
Default
30
2
(swing-leaf)
1
( s l i d i n g )
25
2 25
= ):
532037 - Rev. B