Riello Elettronica Cardin PGM449 Mode D'emploi page 14

The "Add Codes" button will force the following window to appear:
To add new codes you must insert the number
of transmitters which you wish to memorise, the
starting code for the transmitter (first code number
of the block), select the channels to enable and
then press "OK".
Double clicking the dotted box and highlighting a nil code ("---------") will open a window similar to the "Add Codes" menu
in which you can add a new transmitter and enable the corresponding channels.
The "Delete Codes" button allows you to delete codes using the following window:
Enter the start location and the end location
and then press "OK"; if you want to cancel all
the codes press the button "All Locations" and
then press "OK".
If you want to eliminate the location which don't
contain data click the "Compress" box.
The "Import Codes" button opens a window in which you may chooses an installation from which you can partially or
totally import the memorised codes, as will be explained in paragraph 2.4.2
The "Import maintenance personnel" button imports the codes memorised in the list of maintenance personnel (see
paragraph 4.4 )
You may carry out global transmitter channel operations, e.g. you can enable or disable a channel relative to all the
transmitter by means of a simple operation.
Enable a channel in all transmitters: click on the column corresponding to the channel to be enabled (ChA if you want
to enable channel A); the chosen column will become blue. Once the selection has been carried out press the buttons
"CTRL" and "Ins" simultaneously ; at this point the channel ("X") will be enabled for all transmitters .
Disable a channel in all transmitters: click on the column corresponding to the channel to be enabled and then press
the buttons "CTRL" and "Canc" simultaneously.
Copy settings from one channel to another: choose the column to be imported and then press the buttons "CTRL" and
"C" simultaneously; then chose the target column and then press the buttons "CTRL" and "V" simultaneously.
Move settings from one channel to another: select the master column and press "CTRL" + "X" (the relative channel
and all transmitters will be disabled); select the target column and press "CTRL" +"V".
The "SAVE TO DATABASE" button only saves the modifications into a PC archive without transferring the data into the
palm memory.
The "SAVE TO PGM449" button transfers all data into the memory module on the PALM socket and saves the changes
in the PC archive.
If the memory module is protected by a PIN code, you will be asked to input the code before you can transfer the data
from the PC to the PALM.
IMPORTANT!: To enable the connection between the PC and the PGM449 make sure that the PALM is switched on, the
serial cable is correctly attached to the PC and the "CONNECT PC" function has been called up (see the instructions
for the PGM449).
Add Codes
Number of Transmitters:
Channel A Channel B
OK DELETE
Delete Codes
Memory location from:
OK CANCEL
14
Starting Code:
Channel C
to:
All locations
Channel D
Compress