What To Do If - Electrolux EHD 60020 P Notice D'utilisation

What to do if ...

Problem
The appliance cannot be switched
on or is not operating
The cooking zones automatically
reduce the cooking level to
The residual heat indicator is not
displaying anything
acoustic signal sounds, appliance
switches off
A signal sounds when the appli-
ance is switched off
The appliance switches off, a sig-
nal sounds repeatedly
The sensor fields cannot be oper-
ated
Display is switching between two
heat settings
lights up
lights up
Possible cause
More than 10 seconds have
passed since the appliance was
switched on
The lock is switched on
The child safety device is switched
on
Several sensor fields were
touched at the same time
Automatic switch off has been trig-
gered
Dirty control panel
The sensor fields are partly cov-
ered by a damp cloth or with liquid
The cooking zone was only on for
a short time and is therefore not
hot
One or more sensor fields have
been covered for longer than 10
seconds
The control panel is partially or
completely covered by objects
The control panel was covered too
long
A single sensor field was covered
for a short period
Power management is reducing
the power of this cooking zone
Unsuitable cookware
No cookware on the cooking zone Place cookware on the cooking
The diameter of the bottom of the
cookware is too small for the
cooking zone
Automatic switch-off has been
triggered
electrolux 15
Remedy
Switch the appliance on again.
Switch off the lock (See the sec-
tion "Locking/unlocking the con-
trol panel")
Deactivate child safety device (See
the section "Child safety device")
Only touch one sensor field
Remove any objects (pan, cloths,
etc.) that are lying on the control
panel. Switch the appliance on
again
The sensor fields must be dry and
fat-free.
Remove the cloth or the liquid.
Reset the cooking level required.
If the cooking zone is supposed to
be hot, call the Customer Service
Department.
Uncover sensor field
Remove the objects
The appliance will be fully function-
al after about 50 seconds
The sensor field is automatically
released after about 10 seconds
See the section "Switching the
power function on and off"
Use suitable cookware
zone
Move onto a smaller cooking zone
Use suitable cookware
Switch off the cooking zone.
Switch the cooking zone on again