Philips TT3003 Mode D'emploi page 26

Masquer les pouces Voir aussi pour TT3003:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 81
26
English
Problem
The 'ready to flash' light
does not go on when I
place the body attachment
on my skin, but the cooling
fan works.
The 'ready to flash' light is
green but the appliance
does not produce a flash
when I press the flash
button.
The appliance becomes
warm during use.
The appliance does not
show light intensity 1 when
I switch it on.
The appliance produces a
strange smell.
Cause
The safety ring is dirty.
The overheat protection has
been activated.
The appliance needs to be
reset.
This is normal.
The appliance needs to be
reset.
The body attachment is dirty.
Solution
If this does not work, place the appliance
on a part of your body where it is easy
to establish full skin contact, for example
on your lower arm.Then check if the
'ready to flash' light works. If the 'ready
to flash' light still does not go on when
you place the appliance on the skin,
contact the Consumer Care Centre in
your country, your Philips dealer or a
Philips service centre.
Clean the safety ring carefully. If you are
unable to clean the safety ring properly,
contact the Consumer Care Centre in your
country, your Philips dealer or a Philips
service centre to replace the flash screen.
When the overheat protection has been
activated, the fan still works. Do not switch
off the appliance and let it cool down for
approx. 15 minutes before you continue to
use it. If the 'ready to flash' light still does
not go on when you place the appliance on
the skin, contact the Consumer Care Centre
in your country, your Philips dealer or a
Philips service centre.
To reset the appliance, switch off the
appliance and switch it on again. If the
'ready to flash' light is green but the
appliance still does not produce a flash
when you press the flash button, contact
the Consumer Care Centre in your
country, your Philips dealer or a Philips
service centre.
No action required.
To reset the appliance, switch it off
and on again. If the appliance still does
not show light intensity 1, contact your
Customer Care Centre, your Philips
dealer or a Philips Service Centre.
Clean the body attachment carefully.
If you are unable to clean the body
attachment properly, contact the
Consumer Care Centre in your country,
your Philips dealer or a Philips service
centre to replace the body attachment.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Tt3003/61

Table des Matières