Maintenance Instructions - Hoshizaki Advance Serie Manuel D'utilisation, D'entretien Et D'installation

Advance
III.

MAINTENANCE INSTRUCTIONS

This section is particularly intended for the owner/user of the product. It provides important
information on the correct usage and for the maximisation of the product's life span.
We recommend that any technical service is performed by competent trained personnel due to the
nature of mechanical and electrical hazards.
Few simple steps during usage and adjustment can reduce the need for expensive repairs by service
technicians. These steps do not require special technical knowledge.
WARNING: the appliance shall be disconnected from its power source during cleaning or
maintenance and when replacing parts. The removal of the plug has to be such that an operator can
check from any of the points to which he has access that the plug remains removed.
Before you begin cleaning and maintenance on the product, make absolutely sure the power supply
has been turned off and cannot be reconnected accidentally by anyone else.
Do not wash the product with high pressure water. Avoid any possibility spraying into the electrical
components.
CLEANING
•
It is recommended that periodically the inside of the cabinet is cleaned with disinfecting
detergents. Internal cleaning of the cabinet should be carried out by using warm and slightly
soapy water.
•
Only pH neutral or slightly alkaline detergents may be used to clean the interior and the
exterior of the cabinet.
•
Damage caused by cleaning products containing chemicals that could damage stainless steel
is not covered by the warranty.
•
Never use metal implements, metal scouring pads nor scouring creams or powders.
•
Dirt can be cleaned with a damp cloth.
•
Keep the ventilation grilles of the cabinet clean and clear at all times.
•
Shelves are removable for easy cleaning access.
•
Ensure that the shelf runners and shelves themselves are cleaned thoroughly.
The product is made out of stainless steel. When used in normal conditions stainless steel does not
corrode, however corrosion of stainless will occur if corrosive detergents areused.
ROUTINE MAINTENANCE
CONDENSER
It is very important that the condenser is capable of maximum heat transfer. Therefore, the surface
of the condenser must always be clean and clear. Due to the effect of the fan, dust will accumulate
on and inside the condenser fins. A vacuum cleaner with a brush attachment can be used to clean
the condenser.
IMPORTANT
ATTENTION
IMPORTANT
EN
10