VINCENT STU-8 Manuel D'utilisation page 40

Symptom
Does not work after
pressing the power
switch
No sound, LED
"warm up" lights (1)
Audio playback of
a channel does
not work
Poor reception or
no reception
Vincent
40
TROUBLESHOOTING
Possible Cause
Power cable is not connected to a suitable
outlet.
Power cord is not plugged firmly into the
socket and the socket or faulty equipment.
Fuse or device is defective.
Output of the tuner or not wrong or not with
the desired input port of the amp.
There is no set frequency on which a transmitter
can be received with a strong enough signal.
It was not appropriate, to join the band cor-
responding to the antenna tuner.
Wrong input channel selected at the amplifier.
Volume of the amplifier is set too low.
One of the signal cable between the tuner and
amplifier is not firmly plugged in or faulty.
No Antenna or not connected properly.
Interference sources are nearby.
The signal of the FM transmitter is too weak
(may be too far away station).
Remedy
Make a connection to a working electrical
outlet with the appropriate mains voltage.
Check the power cord, replace it if necessary
with a suitable mains cable and press the
plug firmly into the socket and on the other
side into the power jack on the device..
Contact your local dealer.
Correct the connection to the tuner.
Adjust the frequency in a better transmitter. Try
for MW reception, adjust the antenna better.
Attach a suitable antenna (11).
Correct the input selector on the amplifier.
Carefully increase the volume on the amplifier.
Check and tighten the cable.
Check the connection to the selected mode
(FM) associated antenna (11).
Try to locate the fault and eliminate.
Try to improve it by pressing "ENTER" (7/
21) to receive or look for another station.