VINCENT STU-8 Manuel D'utilisation page 37

OPERATION OF THE UNIT – DAB
Action
Hear DAB stations
Use of DAB on startup
Full display
Manual Tune
System Reset
Auto Enter
Vendor text (Stream)
Set Autoscan
Preset Sender
Description
1. Press the POWER button (8) to turn on the device.
2. Press the display, DAB / FM button (4 / 18) to select the DAB transmitter band
3. A channel scan starts automatically (see next action).
4. Press the TUNING button (10/23) to set the received station. If the desired channel is
displayed, press the ENTER key (7 / 21) to listen.
· When you turn on the device for the first time and select DAB. it automatically scans the
Tuning function Band III (7A-13B) frequencies. After the tuning the first found channel
appears.
· Press the AUTO button (5 / 19) and release in less than 2 seconds, to select program
Band III (7 A~13B). Press the AUTO button (5 / 19) longer than 2 seconds and then
release them to carry out the full channel search (complete band III andLband: 5A to
LW) When the automatic channel search is complete, set the number of channels dis-
played, and the first channel.
· When the signal N / A "appears, check the antenna connection.
· Perform a system reset if they use the STU-8 or new location transmitter, connected to
receive program bouquets.
Hold the INFO button (6 / 20) for 2 seconds.
· Manual Tune (Manual tuning)
· System Reset
· Software Version
Press and hold the INFO button (6 / 20) for 2 seconds and then confirm by pressing
the ENTER key (7 / 21). Now use the TUNING buttons (10/23) to search the transmit-
ter manually.
To adjust the tuner with the local DAB transmitter, press the INFO button (6 / 20) for 2
Seconds till the display appears as "Manual Tune", then press the INFO button again,
the display shows "System Reset" then press on the Enter (deletion of the memory is
inzw. completed) which leads to the tuner for a faster channel search and select from
the locally available stations.
Press the ENTER key (7 / 21) for 2 seconds, turn the Auto Input on or off. Thus, the stati-
on will be found after a automatic search is audible without pressing the ENTER key
(hear see "DAB station").
Press when you receive a text, the information provider key (6 / 20) to between to
change the individual broadcast information of the provider.
Press the AUTO button (5 / 19) for a quick scan (The band III Channel between 7A ~
13B). when the AUTO button is pressed longer than 2 seconds, is a Full Scan (Full band
III 5A 13Fand ~ ~ LW LA L-band).
a. With the "Manual Tune" / auto mode, the transmitter in the memory.
b. Press the Preset channel keys (16) on the remote control for 2 seconds
the display shows "Preset XX Saved" while the operation is carried out.
Vincent
37