VINCENT STU-8 Manuel D'utilisation page 34

Use of the analog output on RCA connector
Connect the RCA output sockets "OUTPUT" (13) with the sockets of the high level input of the preampli-
fier, integrated amplifier, receiver or another suitable device (headphone amplifier, recording input of a
tape recorder etc.). In most cases the input is labelled "TUNER," "LINE IN" or "INPUT FRONT R/L". More
information you will find in the user manual of this device.
STU-8
Use of the analog output on XLR connector
Connect the sockets' OUTPUT "(12) with the high level input of an amplifier, preamplifier, receiver or any
other suitable for high-level source device (headphone amplifier, receiving input of a tape recorder, mixing
console, etc.). Usually such an input port is engraved with "LINE IN" or "TUNER". Information about the
connectivity of the device with which the player should be connected can be found in the manual.
STU-8
CONNECTION OF THE POWER CABLE
Check that the electricity supply to your home is appropriate to the device. The required voltage and frequency
can be read on the back of the device beside the socket for the mains. If the electricity supply is appropriate,
push the inlet connector of the supplied mains cable firmly into socket for the mains on the back of the device
(14). Connect the other end of the mains cable to a mains socket.
Vincent
34
CONNECTION TO AMPLIFIER,
RECEIVER OR PREAMPLIFIER
RCA connection
INPUT
S1 S2 S3
XLR connection
Amplifier, Receiver
Amplifier, Receiver