Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Set up the cable links in a sequence as follows. Connect the power cable between device
and power supply only after all other connections have been made.
Protective caps
Prior to the first installation the protective plastic
caps must be removed from all the connections
used at the rear of the unit.
RCA connections
Mechanically identical RCA
plugs are available for analogue and digital out-
puts. Make sure that you do not get these connec-
tions confused during installation!
Make sure that you do not mix up the analogue
connectors for right and left. The RCA plugs for
these are mostly colour coded as follows: red for
the right channel, black or white for the left chan-
nel.
XLR connections
Note that European and US XLR signal use is diffe-
rent. This Vincent device uses the European system
in accordance with Standard AES14-1992 of the
Audio Engineering Society. The structure of the
cable is in any event the same. Provided both con-
nected devices meet the same standard, the signal
connection is correct. This is always the case if
both were manufactured by Vincent. If two devices
with different standards are connected, the signal
will then be inverted. In this case the signal use on
one side of the connection must be changed. Your
specialist dealer will assist you with this.
Vincent
32
INSTALLATION
DURING INSTALLATION PLEASE OBSERVE
THE FOLLOWING ADVICE:
1
2
O UT PU T
OU
US System
1. USA System (Pin 2 = COLD, Pin 3 = HOT)
GND
COLD
2
1
3
HOT
European System
2. Europäisches System (Pin 2 = HOT, Pin 3 = COLD)
GND
2
1
HOT
3
COLD
Cable connections
Make sure that all plugs fit tightly. Inadequate con-
nections can cause noise interference, failures and
malfunctions.
- wrong -
To make the most of the components' sound poten-
tial, only high quality loudspeakers and connecting
cab les, for example Vincent cables, should be
used. Your local stockist will be glad to advise you
about this.
- correct -
Publicité
Table des Matières
