Other Features
FOLLOW ME/TEMP SENSING feature
This feature can be activated from the remote control ONLY. The remote control serves as a remote
thermostat allowing for the precise temperature control at its location. To activate the Follow Me/Temp
Sensing feature, point the remote control towards the unit and press the Follow Me/Temp Sensing
button. The remote control will send this signal to the air conditioner until press the Follow Me/Temp
Sensing button again. If the unit does not receive the Follow Me/Temp Sensing signal during any 7
minutes interval, the unit will exit the Follow Me/Temp Sensing mode.
NOTE: This feature is unavailabe under FAN or DRY mode.
AUTO-RESTART
If the unit shuts off unexpectedly due to a power outage, it will restart with the previously set function
automatically when the power resumes.
WAIT 3 MINUTES BEFORE RESUMING OPERATION
After the unit has stopped, it cannot be restarted until 3 minutes time has elapsed. This is to protect the
unit. Operation will automatically resume after 3 minutes.
AIRFLOW DIRECTION ADJUSTMENT
The louver can be adjusted automatically. Adjust the airfl ow direction automatically.
•
When the Power is ON, the louver opens fully.
•
Press the SWING button on the panel or remote controller to initiate the Auto Swing feature. The
louver will swing up and down automatically.
•
Please do not adjust the louver manually.
Remove
the upper
drain plug
Continuous
drain hose
User Manual
WATER DRAINAGE
•
During dehumidifying modes, remove the upper drain plug
from the back of the unit and install the drain connector (5/8"
universal female mender) with 3/4" hose (locally purchased).
For models without drain connector, just attach the drain hose
to the hole. Place the open end of the hose directly over the
drain area in your basement fl oor.
Page 11