Key Pad Features - Toshiba RAC-WK0512CMRC Instructions D'installation

Air Conditioner Features (Models RAC-WK08 / 10 / 12)
Electronic Control Operating Instructions
Before you begin, thoroughly familiarize yourself with the control panel as shown below and all its
functions, then follow the symbol for the functions you desire. The unit can be controlled by the unit
control alone or with the remote.

Key Pad Features

Connect Indicator Light
(Smart models only)
Timer Sleep
Button Button
TO TURN UNIT ON OR OFF:
NOTE: The unit will automatically initiate the Energy
Saver function under Cool, Dry, Auto modes.
TO CHANGE TEMPERATURE SETTING:
Press UP/DOWN button to change temperature setting.
NOTE: Press or hold either UP (
until the desired temperature is seen on the display.
This temperature will be automatically maintained
anywhere between 17°C (62°F) and 30°C (86°F). If
you want to display the actual room temperature,
see To Operate on Fan Only section.
TO ADJUST FAN SPEEDS:
Press to select the Fan Speed in four steps - Auto,
Low, Med or High. Each time the button is pressed,
the fan speed mode is changed. On Dry mode,
the fan operates on Low speed automatically and
cannot be changed.
On Auto mode,the fan operates on Auto fan
speed automatically and cannot be changed.
SLEEP FEATURE:
Press Sleep button to initiate the sleep mode. In
this mode the selected temperature will increase
by 1(or 2)°C / 2°F 30 minutes after the mode is
selected.
User Manual
A
Mode Up ( ) and Down ( )
Button
.
) or DOWN ( ) button
LED
Display
A
Buttons Button
The temperature will then increase by another
1(or 2)°C / 2°F after an additional 30 minutes. This
new temperature will be maintained for 7 hours
before it returns to the originally selected
temperature. This ends the Sleep mode and
the unit will continue to operate as originally
programmed. The Sleep mode program can
be cancelled at any time during operation by
pressing the Sleep button again.
CHECK FILTER FEATURE:
lter button to initiate this feature.
This feature is a reminder to clean the Air Filter for
cient operation. The light will illuminate
after 250 hours of operation. To reset after
lter, press the Check Filter button
ENERGY SAVER FEATURE (ECO):
Press Energy Saver button to initiate this
function. This function is available on COOL,
DRY, AUTO (only AUTO-COOLING and AUTO-FAN)
modes. The fan will continue to run for 3 minutes
after the compressor shuts o .The fan then
cycles on for 2 minutes at 10 minute intervals
until the room temperature is above the set
temperature, at which time the compressor turns
back on and Cooling resumes.
Energy
Fan
Saver
.
Power
Button
Clean
Filter
Page 11