Through-The-Lens (Ttl) Flash Photography - FujiFilm EF-42 Manuel Du Propriétaire

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26

Through-the-Lens (TTL) Flash Photography

TTL fl ash control automatically adjusts fl ash output for optimal
brightness. The fl ash also responds to changes in camera settings,
allowing the fl ash to be used at shutter speeds slower than the fl ash
sync speed.
To adjust fl ash settings, press MODE until the
icon for the desired item blinks and then press
SEL to choose an option while the red display
backlight is on. Setting is complete when the
backlight turns off and the icon stops blinking.
1
Turn the camera and fl ash on.
2
Press MODE until the icon for the current fo-
cal length display blinks and press SEL to
choose from
(APS-C) or
(35 mm).
3
If
(manual) is selected for zoom, press
MODE until
blinks and press SEL to choose
(auto zoom). Zoom will automatically
be adjusted in response to changes in lens
focal length in the 24 mm–105 mm range
(35 mm format equivalent).
4
Settings are complete when the red backlight turns off . Wait for
the ready lamp to light before taking photographs.
■ TTL Flash Control
The EF-42 instantly calculates the eff ective fl ash range based on
aperture, sensitivity, and other camera settings. When the camera
shutter button is pressed halfway or the
range appears in the bar graph display, which shows distances of
Flash control panel
0.5 m–32 m/1.6 ft.–105 ft. (greater distances are indicated by ).
■ The Ready Lamp
MODE button
SEL button
The ready lamp blinks while the fl ash charges. If the fl ash is fi red im-
mediately after charging, output will be reduced by the equivalent
of about one stop. For maximum fl ash output, wait until the ready
lamp lights. Replace the batteries if charging takes over 30 seconds
following a test fl ash performed with the EF-42 not mounted on the
camera.
■ Performing a Test Flash
To test the fl ash before taking a photograph, check that the ready
lamp is lit and press the test button.
■ Exposure Compensation
Press MODE until the
and press SEL to adjust exposure compensa-
tion.
ENGLISH
icon lights, the
or
icon blinks
EN-8

Publicité

Table des Matières
loading

Table des Matières