Batteries - Clarke Clean Track L24 Mode D'emploi

BATTERIES

If your machine shipped with batteries installed do the following:
• Check that the batteries are connected to the machine (17).
• Turn ON the Key Switch (A) and check the Battery Indicator (D2). If the gauge is completely fi lled, the batteries are ready for use. If the
gauge is less than full, the batteries should be charged before use. See the "Charging The Batteries" section.
• IMPORTANT!: YOUR MACHINE HAS AN ONBOARD BATTERY CHARGER, REFER TO THE OEM PRODUCT MANUAL FOR
INSTRUCTIONS REGARDING SETTING THE CHARGER FOR BATTERY TYPE (SEE CHART).
If your machine shipped without batteries installed do the following:
• Consult your Authorized Clarke dealer for recommended batteries.
• Install the batteries by following the instructions below.
• DO NOT install two 12 volt batteries in your machine. This affects the stability of the machine.
• IMPORTANT!: YOUR MACHINE HAS AN ONBOARD BATTERY CHARGER, REFER TO THE OEM PRODUCT MANUAL FOR
INSTRUCTIONS REGARDING SETTING THE CHARGER FOR BATTERY TYPE (SEE CHART).
AH/Rate MFG
180 DEKA(gel)
195 US
238 US / Trojan
180 Exide
200 Exide
WARNING!
Use extreme caution when working with batteries. Sulfuric acid in batteries
can cause severe injury if allowed to contact the skin or eyes. Explosive
hydrogen gas is vented from the batteries through openings in the battery
caps. This gas can be ignited by any electrical arc, spark or fl ame. Do not
install any lead-acid battery in a sealed container or enclosure. Hydrogen
gas from overcharging must be allowed to escape.
When Servicing Batteries...
• Remove all jewelry
• Do not smoke
• Wear safety glasses, rubber gloves and a rubber apron
• Work in a well-ventilated area
• Do not allow tools to touch more than one battery terminal at a time
• ALWAYS disconnect the negative (ground) cable fi rst when replacing batteries to
prevent sparks.
• ALWAYS connect the negative cable last when installing batteries.
CAUTION!
Electrical components in this machine can be severely damaged if the
batteries are not installed and connected properly. Clarke, a qualifi ed
electrician, or the battery manufacturer should install batteries.
1 Remove the batteries from their shipping crate and carefully inspect them for cracks or other damage. If damage is evident, contact the carrier
that delivered them or the battery manufacturer to fi le a damage claim.
2 Turn the Master Key Switch (A) OFF and remove the key.
3 Tip the recovery tank to the side, locked position. Remove the battery cables from inside the battery compartment.
4 Your machine comes from the factory with enough battery cables to install four 6 volt batteries. Carefully lift the batteries into the battery
compartment and arrange them exactly as shown in FIGURE 1. Secure the batteries as close to the back of the machine as possible.
5 Install the battery cables as shown. Position the cables so the battery caps can be easily removed for battery service.
6 Carefully tighten the nut in each battery terminal until the terminal will not turn. Do not over-tighten the terminals, or they will be very diffi cult to
remove for future service.
7 Coat the terminals with spray-on battery terminal coating (available at most auto parts stores).
8 Put one of the black rubber boots over each of the terminals and connect the Battery Pack Connector (17).
4/12
Algorithm
6
4
4 / 1
51
21
INSTRUCTIONS FOR USE
56091061 - Clean Track
®
ENGLISH - A
FIGURE 1
L24 A - 9