Kongskilde DPC 40 Instructions De Montage page 10

3. Secure the spring brackets. The bracket at the motor end must be mounted using 2 screws/nuts in the two
round holes.
At the opposite end, secure the bracket with a U-bolt through the elongated hole and the bottom round hole.
4. Place the bearing housing with plastic bush on the support rail at the end opposite the motor.
The support rail with brushes and bearings can now be lifted and placed in the previously fitted bearing
housing. The whole unit must be tilted so that the last bearing housing can be secured in the DPC.
- 10 -
Fixing of spring bracket
at motor end.
Use 4 washers and 2
locknuts.
Fixing spring bracket at the
opposite end. Top: Washer
and locknut.
Bottom: Washer, full nut,
locking arm, locknut.
Locking arm