Checking Of The Oil Automatic; Cleaning; Transport; Storage - ATIKA KS 2001/40 Notice Originale

Checking of the oil automatic

Check the function of the automatic chain lubrication by
switching on the chain saw and holding it with the pike in
direction of a carton or paper on the ground.
Do not get in contact with the ground with the chain. Keep
a safe distance of 20 cm.
If an increasing oil track is caused when checking it the oil
automatic works faultless.
If there is no oil track despite full oil tank
clean the oil flow canal (14) and the upper chain
clamping boring (15).
If this is not successful please contact the customer
service.

Cleaning

Clean the chain saw thoroughly after each application so that
the faultless function is kept.
Clean the case with a soft brush or a dry cloth.
Water, solvents and polishing agents shall not be
applied.
Pay attention to that the ventilation slots for the motor
cooling are free (risk of overheating).
In case of harder pollution or resins put the chain for some
hours in a container with chain cleaner. Afterwards wash
up the chain with clear water.
Remove all adhering substances with a brush from the
chain wheel (13) and the sword fastening.
Clean the oil flow canal (14) with a clean cloth.

Possible faults

Before each maintenance and cleaning work
− switch off device
− wait for stop of chain saw
− pull out main plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Chain saw does not initiate
after switching on
Chain saw works with
interruptions
Chain saw picks, vibrates or
does not saw correctly
28
All manuals and user guides at all-guides.com
Possible cause
Chain brake
no power
Extension cable damaged
Main plug, motor or switch defect
external loose connection
internal loose connection
Circuit closer/breaker defect
Chain blunt/worn
Chain worn
Chain tension
Chain not assembled correctly (teeth
face to wrong direction)

Transport

Remove mains plug before each transport.
Transport the chain only with the chain protection put on.
When transporting the product within a car put it in the boot or
on a separate loading area. Secure the chain saw against
tipping over.

Storage

Store unused equipment in a dry, locked place out of the
reach of children.
To extend the service life of the saw and guarantee
smooth operation, before storing for a longer period
thoroughly clean the chain saw
Remove the oil from the oil tank.
Hint:
Some chain oils tend to encrustations after a longer
period. For this reason the oil system should be flushed
before a longer storing with a chain saw cleaner. Fill the
cleaner up to the middle (appr. 50 ml) into the oil tank.
Close the tank. Switch on the chain saw without
assembled guide bar and chain until the complete
cleaner has left the oil opening of the chain saw.
Put the saw chain for a short time into an oil bath and
enwrap it afterwards in an oil paper.
Removal
Release chain brake
Check power supply, power outlet, fuse
protection
Check extension cable, exchange defect cable
immediately
Have motor or switch checked by an approved
electrician or replaced by original spare parts.
Check power supply, power outlet, fuse
protection
Check extension cable, exchange defect cable
immediately
Please contact the after sales service.
Please contact the after sales service.
Chain must be regrinded or exchanged
Exchange chain
Check and adjust chain tension
Assemble chain again