Chicco Baby Hug 4in1 Mode D'emploi page 16

CLEANING
abrasive detergents or solvents. If the highchair comes
into contact with water, dry the metal parts to prevent
the formation of rust.
MAINTENANCE
carried out by an adult.
missing parts: do not use it in this case.
functioning of the product, ensure that all the moving
plastic parts located along the metal frame are free of
dust, dirt and sand.
cone lubricant.
COMPONENTS
chased; check that all of the components listed below
assembled by an adult.
A1 - 4 wheels with brakes
B - Seat frame
E - Fabric (with shoulder straps)
F - Booster cushion
G2 - 3 soft toys
I - Upper fabric zips
N - Backrest recline lever
ASSEMBLY
it, carry out the following assembly operations:
frame on a rug or soft surface so as not to damage the
floor or frame. Assemble the 4 "A1" wheels inserting
frame "A" as shown in figure 1.
WARNING: Fully insert the wheel pin into the hole in
the base. At this point the base can be rested on the
floor.
2. Insert the fasteners of seat frame "B" into the respec-
place (Fig. 2).
3. Assemble the seat (seat frame "B" + seat structure
into the corresponding holes on seat frame "B" until
they click into place (Fig. 3).
WARNING:
ment pedal (I) as shown in Fig. 3a.
4. Insert tube "D" into the corresponding holes on seat
frame "B" until they click into place (Fig. 4).
with the restraint system installed on seat structure
the side fabric holes (FIG. 5), insert the pins of the
arms into the holes on either side of the backrest (FIG.
5a) until they click into place.
WARNING:
rectly.
6. Attach fabric "E" using the two perimeter zips above
seat frame "B" (Fig. 6).
- 7. Pass the crotch strap and waist straps on seat struc-
7c).
8. Attach the fabric (E) to the bottom of seat structure
- right slots (Fig. 8-8a).
BOOSTER CUSHION
seat, place it on the fabric, pass the crotch strap and
waste straps through the holes in booster cushion "F"
(reclined cradle mode), (Fig. 9). In highchair mode it
is also necessary to pass the shoulder straps through
the holes of the booster cushion (Fig. 9a).
TOYBAR
straps through the plastic openings on the bar (Fig.
10) and fastening the velcro.
11. Assemble the toybar (with the light positioned to-
wards backrest recline lever "N") inserting the pins of
the bar into the holes on seat frame "B" until it clicks
into place (Fig. 11).
press the side buttons (Fig. 12).
of the bar support and pull upwards (Fig. 13).
WARNING: Always check that the toybar is properly
fastened before using it.
WARNING:
remove this toy when the child starts trying to get up
on its hands and knees in a crowling position.
HEIGHT ADJUSTMENT
14) and lift or lower the seat to the desired height.
ADJUSTING THE BACKREST
"N" (Fig. 15).
16
-
-
-