Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
b) Bowden cables for the wheel drive
i
This mower has a forward drive and a
reverse drive.
1.) Bowden cable for reverse drive
The Bowden cable for the reverse drive
21
comes out of the housing below the engine
on the right (viewed in the direction of
travel) and is additionally labelled R..
Insert the bent hook of the
22
cable into the lower hole on the inward side
of the right-hand handlebar lever.
Unscrew the foremost nut on the adjuster "a".
23
Insert the adjuster in the holder and
retighten the nut.
Lay the Bowden cable along the inner side
24
of the handlebar console.
Correct adjustment of the Bowden cable:
i
see
under:
cables" in the operating manual of the
mower.
2.) Bowden cable for forward drive
The Bowden cable for the forward drive is
25
on the right side of the housing viewed in
the direction of travel.
Insert the bent hook of the Bowden cable
26.
into the lower hole on the outward side of
the left-hand handlebar lever.
Insert the Bowden cable sleeve "a" into
the holder on the handlebars.
Adjust the lower end of Bowden cable on
27
the housing to the correct setting.
See under: "Adjustment of Bowden cables"
in the operating manual of the mower.
.R.
Bowden
"Adjustment
of
Bowden
c) Bowden cable for cutter bar
The Bowden cable for the cutter bar is on the
left side of the housing viewed in the direction
of travel.
Screw back both nuts on the upper Bowden
28
cable adjuster all the way.
Thread the Bowden cable through the
29
console.
Thread the Bowden cable through guide on
30
the console.
Thread the bent hook through the hole in
31
the holder and push the adjuster up to the
holder.
There is no insertion slit on the holder!
Insert the bent hook through the red
32
handlebar lever.
Set the lower adjuster on the housing to
its middle position.
Correct adjustment of the Bowden cable:
i
See under: "Adjustment of Bowden
cables" in the operating manual of the
mower.
Bind the Bowden cables together with a
33
cable tie on the inner side of the console.
Protective cover
Remove the nuts and washers on the blade
34
holder.
Mount the protective cover and tighten the
35
nuts.
Do not completely tighten the upper nut
(width across flats 19 mm).
Mount the protective cap on the rear of the
36
housing and secure with a hexagonal
drilling screw Ø 4.8 x 16 (1x) and
washer Ø 5 (1x).
GB 2
Publicité
Table des Matières
