GE JX1527 Mode D'emploi page 4

❒
CHECK LEVELING
6
Check the leveling by placing a level at the front
and sides of the microwave. It may be necessary to
add wood shims under the bottom duct to level the
microwave front to back or side to side.
❒
INSTALL THE BOTTOM BRACKET
7
AND SECURE THE TOP BRACKET
Round-Head
Screws
A Drill pilot holes through the three holes on the
front flange of the bottom duct assembly.
Hold the bottom bracket against the front
B
flange of the bottom duct assembly, lining up
the three holes in the bottom bracket with the
three holes in the bottom duct. Screw in three
round-head screws. Drill pilot holes through the
two holes in the tabs on the sides of the bottom
bracket. Screw in two round-head screws.
Drill pilot holes through the side holes in the
C
top bracket. Secure the top bracket to the
cabinet using two round-head screws.
MFL38290502
49-40553-1
10-07 JR
Printed in Korea
Installation Instructions
Cutout
Opening
Positioning
Flange
4
❒
INSTALL THE TRIM FRAME
8
Place the trim frame over the microwave oven
A
with the vent openings at the bottom.
B Press the trim frame into the opening until all
sides snap into place.
C Open the microwave oven door. Secure the
trim frame using four flat-head screws (two on
the inside top and two on the inside bottom).
Flat-Head
Screws
❒
REPLACE ANY LOOSE ITEMS
9
Your trim kit is now fully installed. Replace the
A
turntable and turntable support that were
removed from the inside of the microwave oven.
B Keep these installation instructions and extra
screws for future reference and need. Do not
place them in the microwave oven.
Replace house fuse or close circuit breaker
C
to restore power at the service panel.
Flat-Head Screws