GE JX1527 Mode D'emploi
  1. Manuels
  2. Marques
  3. GE Manuels
  4. Four à micro-ondes
  5. JX1527
  6. Mode d'emploi
GE JX1527 Mode D'emploi

GE JX1527 Mode D'emploi

Masquer les pouces
1
2
3
4
5
6
7
8
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Télécharger ce manuel
Installation
Instructions
Questions? In the U.S., call 800.GE.CARES (800.432.2737)
In Canada, call 1.800.561.3344
❒ BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
•
— Save these instructions
for local inspector's use.
IMPORTANT
•
— Observe all governing codes
and ordinances.
• Note to Installer – Be sure to leave these instructions
with the Consumer.
• Note to Consumer – Keep these instructions for future
reference.
• Skill level – Installation of this appliance requires basic
mechanical and electrical skills.
• Completion time – 1 to 3 hours
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered
under the Warranty.
• This kit is UL/CSA listed for installation alone or over any
GE/GE Profile single electric wall oven. Not for use adjacent
to (within 2 feet of) any gas or electric range, cooktop
or oven.
• For easier installation and personal safety, we
recommend that two people install this microwave oven.
• Unplug the microwave oven before attempting installation
of this kit.
• This kit is for use on models: PEB1590DMBB,
PEB1590DMWW, PEB1590SMSS, PEB159CDNBB,
PEB159CSNSS and PEB159CDNWW.
• Do not alter or modify any part of this kit or the oven.
WARNING
— This oven must be plugged into a
properly grounded 3-hole, 120V receptacle as required by
the National Electrical Code or Canadian Electrical Code.
FOR YOUR SAFETY:
WARNING
— Before beginning the installation,
switch power off at service panel and lock the service
disconnecting means to prevent power from being switched
on accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
Built-In Trim Kits
JX1527 JX1530
GEAppliances.ca.
or Visit our Website at:
PARTS INCLUDED
PART
NOTE: This kit has extra screws to prevent the technician
from spending extra time locating a replacement screw
during installation.
1
ge.com.
or Visit our Website at:
❒ Trim Frame
❒ Bottom Duct
❒ Top Bracket
❒ Bottom Bracket
❒ Upper Duct
❒ Rear Duct
❒ 4 mm x 14 mm
Round-Head
Screws
❒ 4 mm x 14 mm
Flat-Head
Screws
❒ Anti-Tip Brace
❒ Anti-Tip Bracket
❒ Template
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
QUANTITY
1
1
1
1
1
1
22 required
2 extra
4 required
2 extra
1
1
1

Publicité

Table des Matières
loading

Manuels Connexes pour GE JX1527

Sommaire des Matières pour GE JX1527

  • Page 1 Warranty. • This kit is UL/CSA listed for installation alone or over any ❒ Upper Duct GE/GE Profile single electric wall oven. Not for use adjacent to (within 2 feet of) any gas or electric range, cooktop or oven.

  • Page 2: Installation Instructions

    Installation Instructions ❒ TOOLS YOU WILL NEED CUTOUT DIMENSIONS (CONT.) ″ on all sides for overlap On 27″ models, allow 1 ⁄ of the trim frame over the edges of the cutout. ❒ #2 Phillips Screwdriver ″ at the top and bottom On 30″...
  • Page 3 Installation Instructions ❒ ❒ INSTALL BOTTOM DUCT ASSEMBLY INSTALL UPPER DUCT AND TOP TO MICROWAVE OVEN BRACKET Fasten the anti-tip bracket to the bottom duct Remove two screws from back of the using four round-head screws. microwave oven. Peel off the adhesive backing from the upper duct and secure it to the microwave oven by pressing it firmly down FRONT...
  • Page 4 Installation Instructions ❒ ❒ CHECK LEVELING INSTALL THE TRIM FRAME Check the leveling by placing a level at the front Place the trim frame over the microwave oven and sides of the microwave. It may be necessary to with the vent openings at the bottom. add wood shims under the bottom duct to level the Press the trim frame into the opening until all microwave front to back or side to side.
  • Page 5 électrique simple GE ❒ Conduit supérieur ou GE Profile. Ce four à micro-ondes ne peut être installé à moins de 2 pieds d’une cuisinière au gaz ou électrique, d’une surface de cuisson ou d’un four.

  • Page 6: Outils Nécessaires

    Instructions d’installation ❒ OUTILS NÉCESSAIRES DIMENSIONS DE L’OUVERTURE (SUITE) Sur les modèles de 27 po, prévoyez un espace de 1 ⁄ po sur tous les côtés pour permettre le chevauchement du cadre de finition ❒ Tournevis Phillips n° 2 sur les bords de l’ouverture. Sur les modèles de 30 po, prévoyez un espace de 1 ⁄...

  • Page 7: Montage Du Conduit Supérieur Et Du Support Supérieur

    Instructions d’installation ❒ ❒ MONTAGE DU CONDUIT INFÉRIEUR MONTAGE DU CONDUIT SUPÉRIEUR DU FOUR À MICRO-ONDES ET DU SUPPORT SUPÉRIEUR Fixez le support antibasculement au conduit inférieur au Retirez les deux vis à l’arrière du four à micro-ondes. moyen de quatre vis à tête ronde. Retirez le film protecteur du conduit supérieur et fixez ce dernier au four à...

  • Page 8: Vérification Du Niveau

    Instructions d’installation ❒ ❒ VÉRIFICATION DU NIVEAU MONTAGE DU CADRE DE FINITION Pour vérifier la mise à niveau, placez un niveau à l’avant et sur les Placez le cadre de finition sur le four à micro-ondes en côtés du four à micro-ondes. Il se peut que vous deviez ajouter orientant les ouvertures des évents vers le bas.

Ce manuel est également adapté pour:

Jx1530

Table des Matières