Package Contents - K2 Pumps SPC03301K Manuel Du Propriétaire

PACKAGE CONTENTS

NOTE: Do not reduce size of discharge pipe or hose below 1-1/2 in. diameter. If discharge is too small, pump will
overheat and fail prematurely. This pump is designed for use in a residential sump only. Only pump water with this
pump.
INSTALLATION
1. Drain the sump pit as far as possible without running the pump dry. Do this by:
A. Piggyback switch: Unplug the pump and switch from the outlet, then unplug the pump from the piggyback switch.
Reset the circuit breaker or reinstall the fuse and plug the pump directly into the outlet. The pump will start. Drain the
pit and unplug the pump. OR
B. No piggyback switch: Reset the circuit breaker or reinstall the fuse and use a non-conducting broom handle or
stick to raise the float switch; the pump should start. Drain the pit and then release the switch. When the pit has
drained, turn off (open) the circuit breaker or remove the fuse again to avoid electrical shock while working on the
installation. Unplug existing sump pump and place power cord and piggyback switch out of the way of work and
water.
2.
Measure the height from sump bottom to sewage pipe joint, make sure to leave enough discharge pipe.
3. Use hacksaw to cut the drain pipe to the length meeting the installation requirement.
NOTICE: Depending on where your current check valve is located, there may be excess water. Let the water
drain/drip into the sump pit.
For Professional Technical Support call 1-844-242-2475
Part Description
A Pump
B Battery box
C adaptor
5