Tools Required; Materials Required (Not Included) - K2 Pumps SPC03301K Manuel Du Propriétaire

NOTICE: Do not reduce size of discharge pipe or hose below 1-1/2" diameter. If discharge is too small, pump will
overheat and fail prematurely.
NOTICE: If a Carbon Monoxide (CO) sensor is installed, it must be at least 15 feet away from battery charger in order
to avoid nuisance CO alarms. Please refer to your CO detector's installation guidelines for more information.
PRE-INSTALLATION
APPLICATION
 This compact primary and backup pump system is designed for home sump applications. Use this pump only for
pumping water.
This unit is not designed as a waterfall or fountain pump, or for applications involving salt water or brine! Use with

waterfalls, fountains, salt water or brine will void warranty.
Do not use where water recirculates.

Not designed for use as a swimming pool drainer.


TOOLS REQUIRED

Flathead
Screwdriver
Hacksaw

MATERIALS REQUIRED (NOT INCLUDED)

NOTE:
Parts shown below not to scale.
1-1/2'' ABS or
PVC Pipe
1-1/2"
Coupling
4
Phillips
Screwdriver
Cable
Ties
Thread Tape
ABS or PVC
Cement
(to match the
pipe)
Channel
Locks
Safety
goggles
For Professional Technical Support call 1-844-242-2475
Pipe wrench
Tape
Measure
1-1/2" 90°
Elbow