HP Photosmart C6200 All-in-One Série Guide D'utilisation page 16

Chapter 3
To load full-size paper
1. Pull out the main input tray, and then slide the paper-width and paper-length guides
to their outermost positions.
2. Tap a stack of paper on a flat surface to align the edges, and then check the paper
for the following:
• Make sure it is free of rips, dust, wrinkles, and curled or bent edges.
• Make sure all the paper in the stack is the same size and type.
3. Insert the stack of paper into the main input tray with the short edge forward and the
print side down. Slide the stack of paper forward until it stops.
TIP:
down. For more help on loading full-size paper and letterhead, refer to the diagram
engraved in the base of the input tray.
4. Slide the paper-width and paper-length guides inward until they stop at the edges of
the paper.
Do not overload the main input tray; make sure the stack of paper fits within the input
tray and is no higher than the top of the paper-width guide.
16 HP Photosmart C6200 All-in-One series
If you are using letterhead, insert the top of the page first with the print side